The Maintenance and Repair of Crusher Wear Parts
Author: Winner Group Time: 2017-08-21
Compared with the host, the wear-resistant crusher parts are generally small parts. In the course of the operation, most of these crusher parts directly contact with limestone and other materials, crusher performance and efficiency will reflect through the work of these wear-resistant parts.
The role of wear-resistant crusher parts is also very important, and the quality of wear-resistant parts can directly affect the performance, life span, work efficiency and engineering cost of the crusher. If the wear and tear failure is not replaced in time, continue to use will damage the machine. Because the resistance is too large, the force is unbalanced, and the crusher will vibrate when working which will damage the crusher host.
Bearing: the bearing of the crusher bears the full load of the machine, so good lubrication has a great influence on bearing life, which directly affects the service life and operation rate of the machine. The lubricating oil must be cleaned and the seal must be well sealed. Body: the surface of the machine has holes, shrinkage, slag, cracks and other phenomena, and should be repaired or replaced in time. Liner: to prohibit the crusher into the non-crushed material, but when the crusher into the metal or lining off, it is likely to cause damage or bending in the hammer, then need to be replaced in time, or easy to lose hammer caused vibration.
Check the triangular belt tension and wear, check the cable and electrical components, to avoid disconnection and wear, repair the fault found in time, and comply with electrical safety and inspection system.
Next Article: Solid Waste Management Should be Put on Schedule
Please Feel free to give your inquiry in the form below. We will reply you in 24 hours.